Table of Contents
Advertisement
User's Manual
Mail Settings (NETWORK Mail Tab)
The DVR can be set up to send an e-mail when an event occurs.
Highlight Enable and press the
the settings if Mail is enabled.
Highlight the box beside SMTP Server and press the
use to enter the IP address or domain name of the SMTP server.
NOTE: You will need to get the IP Address or domain name of the SMTP Server from your network
administrator.
NOTE: You can use the domain name instead of IP address if you already set up the DNS Server
when setting up the LAN.
Highlight the box beside Port and press the
port number obtained from your system administrator. The default port number is 25.
Highlight Use SSL/TLS and press the
can send an e-mail via an SMTP server requiring SSL (Secure Sockets Layer) authentication.
Highlight the box beside Authentication and press the
NOTE: This product includes software developed by the OpenSSL Project for use in the OpenSSL
Toolkit (http://www.openssl.org/).
Highlight the box beside Sender and enter the sender's e-mail address. Use the virtual keyboard to enter
the e-mail address.
NOTE: The e-mail address must include the "@" character to be a valid address.
Highlight the box beside Recipient and enter the recipient's e-mail address. Use the virtual keyboard to
enter the e-mail address.
You can save your Mail changes by highlighting Save and pressing the
the screen without saving the changes.
34
Figure 23 ─ Mail setup screen.
button to toggle between On and Off. You will only be able to change
button. Use the arrow buttons to enter the SMTP Server
button to toggle between On and Off. When it is On, the DVR
Highlight Use and press the
Highlight the box beside User/Password and press the
keyboard appears allowing you to enter the user ID and password.
button. A virtual keyboard appears that you can
button. An Authentication screen appears.
button to toggle between On and Off.
button. Selecting Cancel exits
button. A virtual
Advertisement
Table of Contents
