Mitsubishi Electric NM-C150SD Installation And Operation Manual page 29

 RTP Setting
Have a setting for sending and receiving an audio or video on a real-time basis.

Stream RTP after Network Dome Camera start-up
Enter a destination IP and Port to send movie data automatically through the RTP
while the Network Dome Camera has booting.
Send to DHCP server IP: Send movie data to the DHCP server.
Send to (Client) IP: Send movie data to other certain destination addresses.
Use RTP destination Port: Available from 1024 to 65532, and the default is 5000.
Do not send: Do not send a stream to the FTP until it is requested from a client.
Enable multi stream
Check it to send data for the purpose of saving them into an external extension
storage right after the Network Dome Camera operates.
-Send to secondary client ip: Enter an IP address of the external extension storage.
-Use RTP destination port: Enter a Port number of the external extension storage.
The Port number to be used is [1024 ~ 65532].
-Frame rate: Indicate a frame rate that is sent to the external extension storage when
the multi stream works.
Once the multi stream function is checked, the MPEG profile setting will be changed to
the Advanced Simple Profile.

RTSP/RTP settings
Perform a multicast setting to send a video and audio to multiple users. (Up to 10 users)
RTP destination IP
Disable Multicast: Do no use the multicast.
Enable Multicast: Use the multicast.
- 24 -