How To Mount And Attach Options To The Lcd Monitor; To Avoid Monitor From Falling - Mitsubishi Electric LDT322V User Manual

How to Mount and Attach Options to the LCD Monitor

1. Lay the screen face down
394.5
100 100 100
Table
Lay the protective sheet on a table, which was wrapped
around the monitor when it was packaged, beneath the
screen surface so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop
Stand or other mounting accessory. Failure to follow correct
mounting procedures could result in damage to the equip-
ment or injury to the user or installer. Product warranty does
not cover damage caused by improper installation.
Failure to follow these recommendations could result in void-
ing your warranty.
When using with other mounting accessory, the screws must
be M6 of size and 10 mm or longer of length under consid-
eration of the thickness of the mounting method. Tighten
the screws securely. (Torque : approx. 5.49 N·m) Prevent the
screws from loosening using spring washers, etc.
MITSUBISHI ELECTRIC recommends using mounting inter-
face that comply with TÜV-GS and/or UL1678 standard in
North America.
2. Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding
objects as shown in the diagram below.
394.5
Protective
100
Sheet
(mm)

3. To avoid monitor from falling

When installing the monitor using the tabletop stands (op-
tional), take measures to prevent it from falling over in case
of an earthquake or other disaster to lessen the probability of
injury and damage resulting from fall.
As shown in the fi gure, secure the monitor to a solid wall or
pillar using rope (commercially available) strong enough to
bear the weight of the monitor. (LDT322V : approx. 15.7 kg
(with the optional stands))
When you use screw hooks (commercially available), ring
screw hooks, not C-shaped screw hooks (with opening), are
recommended.
360 mm
Screw Holes
Clamper
Screw
Before moving the LCD monitor, the cord or chain should be
removed.
Caution:
• Install the monitor with metal brackets for wall or ceiling
installation (commercially available) on your own respon-
sibility. For detailed procedures of installation, refer to the
instructions of the metal brackets.
• The effectiveness of preventing from falling substantially
depends on the strength of brackets and base to which
prevention device from falling is attached. When you
cannot ensure suffi cient strength, provide adequate
reinforcement.
• Though the recommended prevention from falling is
intended to lessen the probability of injury and damage, it
doesn't assure its effectiveness against any kind of
earthquake or disaster.
• To lessen the probability of injury and damage resulting
from fall of the monitor in case of earthquake or other
disaster, be sure to consult the bracket manufacturer for
installation location.
• Do not sleep where the monitor may topple over or fall in
case of an earthquake or other disaster.
• Before moving the monitor, remove the rope that is
securing the monitor. Failure to do so may result in injury
or breakdown of the monitor.
1-14
Screw hook, etc.
commercially available
Rope, etc.
commercially available