Philips Salon Multistylist HP4696 Ower's Manual

2
Take a lock of hair and wind it round the brush (Fig. 7).
3
Remove the brush from your hair after 5 to 10 seconds. Let the waves cool
down before combing, brushing or finger-combing the hair into its final style.`
Ringlets
1
Connect the spiral attachment to the handle. Make sure that the stand is
pointing downwards.
2
Take a lock of hair, open the clip by pressing the lever and place the lock
between the barrel and the clip (Fig. 8).
3
Release the lever and slide the barrel to the end of the lock. Then wind the
lock round the barrel following the spiral profile. Make sure that the end of
the lock is wound in the required direction.
4
Open the clip after 5 to 10 seconds and remove the barrel from the hair.
Let the ringlets cool down before combing, brushing or finger-combing the
hair into its final style.
Crimps
1
Connect the crimping/straightening attachment with crimping plates to the
handle (Fig. 9).
2
Take a lock of hair (max. 5 to 6 cm wide), open the attachment by pressing
the lever and place the lock between the plates of the crimping/straightening
attachment. Start crimping at the roots (Fig. 10).
3
Keep the plates locked for 5 to 10 seconds.
4
Open the attachment by pressing the lever and place a lower section of the
same lock of hair between the plates. Make sure there is an overlap. Repeat
this process until you have reached the end of the lock.
5
Let the crimps cool down. Do not brush or comb the crimps, as this would
ruin them.
The waves, curls and crimps will disappear if your hair gets wet (for instance when
you wash it). You can also use the straightening plates to make them disappear.
Sleek look
1
Open the crimping/straightening attachment. Remove the plates one by one by
grabbing their cool tips and pulling them out of the attachment (Fig. 11).
2
Turn the plates round and slide them back into the attachment (Fig. 12).
Make sure that the edges of the plates are inserted properly into the grooves.
3
You have now turned the crimping attachment into a straightening attachment.
Connect the attachment to the handle and follow the same procedure as
for creating crimps. You can also straighten the hair by slowly sliding the
straightening attachment down the lock.
4
Let the sleek hair cool down before combing or brushing the hair.
Cleaning
Always unplug the appliance before cleaning it.
Never rinse the appliance with water.
Place the styler on the stand of the attachment in a safe place and let it cool
,
down.
Clean the appliance and the attachments with a small brush or a dry cloth.
,
Storage
Always unplug the appliance before storing it.
Place the styler on the stand of the attachment in a safe place and let it cool
,
down.
Do not wind the mains cord round the appliance.
,
Replacement
If the mains cord is damaged, it must be replaced by Philips, a service centre
authorised by Philips or similarly qualified persons in order to avoid a hazard.
Always return the appliance to a service centre authorised by Philips for examination
or repair. Repair by unqualified people could cause an extremely hazardous situation
for the user.
Environment
Do not throw the appliance away with the normal household waste at the end
,
of its life, but hand it in at an official collection point for recycling. By doing this
you will help to preserve the environment (Fig. 13).
Guarantee & service
If you need information or if you have a problem, please visit the Philips website at
www.philips.com or contact the Philips Customer Care Centre in your country
(you will find its phone number in the worldwide guarantee leaflet). If there is no
Customer Care Centre in your country, turn to your local Philips dealer or contact
the Service Department of Philips Domestic Appliances and Personal Care BV.
Troubleshooting
If problems should arise with your styler and you are unable to solve them by means
of the troubleshooting guide below, please contact a Philips service centre or the
Philips Customer Care Centre in your country.
HP4696/07 Salon Multistylist
www.philips.com
Problem Solution
The appliance Perhaps there is a power failure or the socket is not live.
does not work
at all.
Check if the power supply is working. If it is, check whether
the socket is live by plugging in another appliance.
Perhaps the appliance overheated and switched itself off.
Unplug the appliance and let it cool down for a few minutes.
Make sure that the voltage indicated on the appliance
corresponds to the local mains voltage.
Perhaps the mains cord of the appliance is damaged.
The mains cord must be replaced by Philips, a service centre
authorised by Philips or similarly qualified persons in order to
avoid a hazard.
The styling results Perhaps you didn't let the appliance heat up long enough.
are not what you
expected.
Let the appliance heat up until the ready dot has changed
colour.
Perhaps you wound too much hair round the barrel or put
too much hair between the plates.
When using the curling attachments or the slide-on brush, do
not make the locks too thick. The thinner the lock of hair, the
tighter the curl will be. When using the crimping/straightening
attachment, make sure the locks are no wider than 5 to 6 cm
for a good result.
Perhaps you didn't leave the styling attachment in your hair
long enough.
Keep the styler in your hair for 5 to 10 seconds, depending
on the thickness of your hair.
u
4222.002.6848.1