Table of Contents
Advertisement
Troubleshooting Guide
When Other Panasonic Products
Respond to this Remote Control
Use this function to synchronize the codes for the remote
control and the main unit when there are other Panasonic
products close to your unit.
With the unit stopped
Press [FUNCTION MENU].
Press [ e , r ] to select "Others", then press [OK].
Press [ e , r ] to select "Setup", then press [OK].
Press [ e , r ] to select "Others", then press [OK].
Press [ e , r ] to select "Remote Control", then
press [OK].
Press [ e , r ] to select the code ("BD 1", "BD 2" or
"BD 3"), then press [OK] to set.
While pressing and holding [OK],
press and hold the numbered button [1], [2] or [3]
corresponding to the code set in step
than 5 seconds to set.
Press [OK] to complete.
8
When the following indicator appears on the unit's display
–
Change the code on the remote control to match the code
displayed for the main unit (➔ step
Tips
To return to the previous screen
Press [BACK/RETURN ].
To exit the screen
Press [EXIT].
Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the solutions
indicated in the chart do not solve the problem, consult your dealer for instructions.
Updating to the latest software may solve the problem. (➔ 111)
The following does not indicate a problem with the unit:
•
Regular disc rotating sound.
•
Poor reception due to atmospheric conditions.
•
Image disturbance during search.
•
Periodic interruptions to the reception due to satellite broadcasting breaks.
•
Operations are slow to respond when "Power Save" is set to "On".
•
Operations are not working due to a poor-quality disc. (Try again using a Panasonic disc.)
•
The unit freezing due to the activation of one of its safety devices (➔ above, To restore the unit if it freezes).
•
When the unit is turned on or off, there may be an unexpected sound.
122
RQT9430
for more
).
To reset this unit
To reset the unit's settings
All the settings except for the ratings level, PIN , Owner
ID and Clock, etc. return to the factory preset. The timer
recording programmes are also cancelled.
PIN for BD-Video playback, DVD-Video playback, Child
Lock, Parental Control and VIERA CAST
On the main unit
Press and hold [ 2 CH] and [CH 1 ] for about 5
seconds.
–
"freesat Auto Setup" (➔ 98) starts.
To reset the unit's settings by using
the menu, see page 107.
To reset the ratings level settings
With the unit stopped
Press [ ; OPEN/CLOSE] to open the disc tray.
Press [DRIVE SELECT] to select the BD drive.
On the main unit
Press and hold [ * REC] and [ q /✕1.3] for about 5
seconds.
To restore the unit if it freezes
On the main unit
Press and hold [ 8 ] for more than 10 seconds.
–
The unit is turned in standby.
To eject the disc forcibly
On the main unit
Press [ 8 ] to switch to standby mode.
–
If the unit doesn't switch to standby
mode, restore the unit. (➔ above)
While the unit is turned in standby
Press and hold [ g ] and [CH 1 ] at the same time
for about 5 seconds.
Advertisement
Table of Contents
