Contents 1 Important Safety Notice 2 Your Wireless Microphone and Bluetooth Speaker ® Introduction What's in the box Overview of the unit 3 Get started Connect power Switch on the Bluetooth speaker ® Install/replace microphone batteries 4 Play Sing along through the wireless microphone Play from a Bluetooth enabled device...
1 Important i Do not expose the product to dripping / splashing water, rain or high humidity. j Keep this product away from direct sunlight, naked flames or heat. k Do not install near any heat sources Safety such as radiators, heat registers, stoves, or other electrical equipment (including Information for Europe: amplifiers).
Any changes or modifications made to this waste.Please inform yourself about the local device that are not expressly approved by rules on separate collection of batteries Philips Consumer Lifestyle may void the user’s because correct disposal helps to prevent authority to operate the equipment. negative consequences for the environmental and human health.
Page 6
registered in the U.S. and other countries. The Bluetooth word mark and logos are ® registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Philips is under license. Note • The type plate is located on the back of the unit.
Write the numbers here: Model No. __________________________ Serial No. ___________________________ Introduction With the Philips wireless microphone and Bluetooth speaker, you can: ® • dock your iPad onto the speaker to a Line out socket sing along with music from the app • (To use the microphone separately)
Page 8
c de • Turn the unit on/off. b Power/Bluetooth indicator ® • Indicate the power/Bluetooth status. ® c -/+ • Adjust volume. • (Press) pair with a Bluetooth enabled ® device that supports A2DP (Advanced Audio Distribution Profile). • (Press and hold) pair with the wireless microphone in case automatic pairing fails.
3 Get started • To switch the unit on from standby mode, press again. Always follow the instructions in this chapter in • sequence. If the speaker stays idle for more than 15 minutes, it switches to standby mode automatically. Connect power Install/replace microphone Caution batteries • Risk of product damage! Make sure that the power supply voltage corresponds to the voltage printed on the back of the unit.
Page 10
Push back the battery cartridge, then close the battery compartment. Note • If you are not going to use the microphone for a long time, remove the batteries. • New batteries installed in the microphone support up to 30 hours of continuous use. • When the power indicator flashes red, it indicates that the power level is low and you need to replace the batteries.
4 Play Sing along through the wireless microphone Note • The effective operation range between the wireless microphone and Bluetooth speaker is approximately ® Slide the OFF/ON switch on the wireless 10 meters (30 feet). microphone to the ON position. »...
Play from a Bluetooth ® enabled device Note • The effective operation range between the Bluetooth ® speaker and your Bluetooth enabled device is ® approximately 10 meters (30 feet). • To pair with a Bluetooth enabled mobile device, make ® sure that: no iPad is docked;...
Select 'PHILIPS_AEA7000/10' on your Play and charge your iPad Bluetooth enabled device and if necessary ® through the dock connector input '0000' as the paring password. directly » After successful pairing and connection, the Bluetooth indicator on the ® Compatible iPad speaker turns solid blue and the speaker beeps twice.
Charge the iPad The docked iPad begins to charge as soon as the unit is connected to AC power. Play from an external device You can also listen to an external audio player through the Bluetooth speaker. ® AUDIO-IN Connect a 3.5mm audio cable to: • the AUDIO-IN socket on the back of the Bluetooth speaker.
5 Product Dimensions (W x H x D) information • Speaker 300 x 162 x 148mm • Microphone 162 x 333 x 162mm Weight Note 2.5 kg • With Packing • 1.5kg • Main Unit Product information is subject to change without prior notice.
10 requesting service. If the problem remains ® seconds to set up wireless connection unsolved, go to the Philips Web page (www. philips.com/support). When you contact Philips, manually. make sure that the device is nearby and the Howling or echo from the wireless model number and serial number are available.