Connections - Sanyo TLS-1960P Instruction Manual

RQ4Q/EX (TLS-1960P GB) Wed. May, 08/2002

CONNECTIONS

Connect the video camera and TV monitor as shown in the figure below.
NOTE:
Before making the connections, make sure the devices are disconnected from the power outlet.
AC IN
Power cord
Power Cord Installation
1
Plug the power cord (supplied) into the AC power
input (AC IN ~) on the VCR back panel. Insert the
plug straight and firmly.
2
Insert the AC power cord into the holder.
3
Fix the holder to the VCR back panel.
Video camera
(sold separately)
From an external
audio source
DC12-24V IN
COM
Holder
To outlet
NOTES:
œ For more details, please refer to the manuals
œ You can use a VA-RMN01 Remote Control Unit (sold
AC power cord
œ If there is no video signal when the power is turned
NOTES (TLS-1960P only):
Holder
œ Use a DC power cord rated A.W.G 18 (1.25 mm
œ The table below indicates the DC power source output
8
TV Monitor (sold separately)
To
VIDEO
IN
jack
RS232C A RS485 B
TERMINATE
OFF ON
Do not connect to phone line.
OPEN COLLECTOR (Max. 1=500mA, 2=50mA)
AUDIO VIDEO
SEE MANUAL
IN OUT IN OUT
REMOTE MIC IN
To
VIDEO
OUT
jack
To remote control
(sold separately)
accompanying all other devices. If the connections
are not made properly, it may cause a fire or damage
the equipment.
separately) to control the VCR remotely.
on, "NO VIDEO" will be displayed on-screen.
more.
and DC power maximum cord lengths.
DC power source output
18 V or more 2 A
12 ~ 16 V 3 A
Coaxial
cable
(sold
separately)
2
) or
DC power maximum
cord lengths
6 m
6 m
English