Identification Of Controls - Sanyo LED-22XR10F Instruction Manual

Main Unit (front/side view)
1 2
SOURCE MENU
3 4 5
Note: B uttons on the TV control panel (CH / ,
VOL+/-, MENU, SOURCE, POWER
buttons. First touch of the button will illuminate it.
Second touch will fulfill its function. Be sure
button presses must be quickly done before
the illumination disappears.
Main Unit (back view)
11
HDMI 1
PC IN
MUSIC/AUDIO RF
D-Sub
10
9 8

Identification of Controls

1. Remote sensor
Receives signals from the remote control.
Do not block.
2. Power indicator
Lights blue when in operating mode.
Lights red when in standby mode.
SOURCE MENU CH VOL
3. POWER
Press this button to turn the unit ON from STANDBY mode. Press it
again to turn the set back to STANDBY.
+
CH VOL
4. SOURCE
To access SOURCE menu
6 7
5. MENU
^
^
Press this button to access the main menu screen.
) are touch
6. CH
Press these two buttons to directly change the TV channel;
In menu operations, these buttons serve as up/down buttons.
7. VOL+
Press the VOL+ or VOL– button to directly increase or decrease
the sound volume level;
In menu operations, these buttons serve as right/left buttons.
8. Power Switch
8
^
/
^
/–
1. RS-232: For service only. Do not use.
2. AV OUTPUT: Connect a VCR to these jacks to record
1
programs.
3. USB port: Connect a USB device to this port.
2
4. HDMI2: Connect an HDMI device to this jack.
5. Headphone & S/PDIF:
Connect headphones to this jack.
3
Connect a digital sound system to this jack.
6. COMPONENT IN: Connect a component video device
4
to these jacks.
5
7. AV INPUT: Connect an AV device to these jacks.
8. RF: Connect an antenna to this jack.
9. PC IN D-SUB/AUDIO: Connect a computer to these
jacks.
6
10. MUSIC: Connect a MP3 player to this jack.
11. HDMI1: Connect an HDMI device to this jack.
7
7