Sharp XL-35H Quick Start Manual

Micro component system

Hide thumbs Also See for XL-35H:

Download this manual See also: Operating Manual

MICRO COMPONENT SYSTEM

This Quick Start Guide will help you to correctly install and

operate your system.

If you require any advice or assistance regarding

your Sharp product, please visit our web-site

www.sharp.co.uk/customersupport.

Customers without Internet access may telephone

08705 274277 during office hours (or (01) 676 0648

if telephoning from Ireland).

Accessories

AC power lead

Remote control

Use 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).

Batteries are not included.

MODEL

XL-35H

0101

FM/AM loop aerial

– 1 –

Remote control battery installation

Remove the battery cover.

Insert the batteries as shown.

Replace the cover.

TINSE0111SJZZ

02J N YT 1

Table of Contents

Page 1: Remote Control Battery Installation
This Quick Start Guide will help you to correctly install and operate your system. If you require any advice or assistance regarding your Sharp product, please visit our web-site www.sharp.co.uk/customersupport. Customers without Internet access may telephone Insert the batteries as shown.
Page 2: System Connections
System connections AM loop aerial aerial Right speaker VCR, DVD, etc. Left speaker To the line output sockets RCA lead (not supplied) Turn on your system Wall socket Press the ON/STAND-BY button to turn (AC 230 V, 50 Hz) the power on. Right speaker Left speaker White line...
Page 3: Listening To A Cd
Listening to a CD Listening to the radio PUSH CLOSE Press the FUNCTION button until “CD STOP” appears on the dis- Press the FUNCTION button until “FM” or “AM” appears on the play. display. Press the TUNING ( ) button to tune in to the desired sta- Press the CD EJECT button to open the CD compartment.
Page 4: Listening To A Cassette Tape
Listening to a cassette tape Clearing all the memory (reset) 1 Press the ON/STAND-BY button to enter the power stand-by mode. 2 Unplug the AC power lead from the AC INPUT socket on the unit. 3 Whilst pressing down the MEMORY/SET button and the button, plug the AC power lead into the AC INPUT socket on the unit.