Basic Operations; Setting The Code For Non-Sony Preset Audio And Visual Components - Setting Component Codes; Setting A Component Code - Sony RM-VL610T Operating Instructions Manual

Basic Operations

Setting the Code for non-Sony
Preset Audio and Visual
Components
— Setting component codes
The Commander is preset at the factory to operate
Sony brand AV components (see the table below). If
you are using the Commander with a factory-set
Sony components, skip the following procedures.
You can use the Commander with other major
brand preset AV components also. To use with other
AV components, or Sony components which do not
function with the Commander, you need to follow
the procedures to set the correct codes for each
component.
Component Select Preset
button component(s)
TV TV
TV/VCR Combo
DVD DVD player
SAT Satellite tuner
CBL Cable box
VCR VCR
CD CD player
TAPE Cassette deck
AMP Amplifier
Note
An MD player can be set to any of the above Component
Select buttons. You can assign Component Select buttons to
freely set signals of your desired components. For further
information, see "Assigning Other Components to the
Component Select Buttons" (page 24) .
For the functions of buttons as for each component, see
"Table of Preset Functions" (page 30).

Setting a component code

8
Factory setting
Sony TV
Sony DVD player
Sony satellite tuner
Analogue cable box
Sony VHS VCR
Sony CD player
Sony cassette deck
Sony amplifier
Example: To set up a Philips' TV
1
See the tables in the supplied "Component
code numbers," and find the four-digit
component code number for the desired
component.
If more than one code number is listed, use the
number that is listed first.
For example, to set up a Philips' TV, you would
use the code number 8086.
2
Press and while holding SET, press MENU.
The SET indicator lights up.
3
Press the Component Select button for the
desired component.
The SET indicator and the selected Component
Select button light up.
4
Press the Number buttons to enter the
four-digit component code number.
5
Press ENT.
The SET indicator and the Component Select
button light turn off.
If the Component Select button flashes five
times before turning off, it means that the setup
is incomplete. Start over from Step 2.