Sharp AL-2050 Online Manual page 30

3 TROUBLESHOOTING
Troubleshooting
Problem
The machine does not print.
CO NT E N TS
The printer driver has not been installed properly.
→ Follow these steps to check and see if the printer driver is installed.
1 Click the "start" button, click "Control Panel", click "Printers and Other Hardware",
and then click "Printers and Faxes".
● On Windows Vista, click the "Start" button, select "Control Panel", and then click
"Printer".
●
On Windows 98/Me/2000, click the "Start" button, select "Settings" and then click
"Printers".
2 Does the "SHARP AL-XXXX" printer driver icon appear?
3 If the icon is shown but you still cannot print, the printer driver may not have been
installed correctly.
In this case, delete "SHARP AL-2050/2060 Series MFP Driverr" and then reinstall
it.
A copy job is in progress.
→ Wait until the copy job is finished.
The size of paper loaded in the tray is different from the paper size setting in the
machine.
→ Make sure that the size of paper loaded in the tray and the machine's paper size
setting agree.
The specified size of paper has not been loaded.
→ Load the specified size of paper in the paper tray.
The "FORCED OUTPUT" setting is set to "OFF".
→ When "FORCED OUTPUT" is set to "OFF" and there is no paper in the machine that
is the same size as the print image, load paper in the bypass tray as instructed by the
message in the display and press the [START] key to begin printing. (The bypass tray
cannot be used for two-sided printing.) If "FORCED OUTPUT" is set to "ON", the job
will be printed on the paper in the machine even though if it is a different size.
I N D E X
Cause and solution
(part 2)
Page
-
-
Operation
Manual
Operation
Manual
6
30