Yamaha KODIAK YFM4FAV Owner's Manual page 127

10. Install the engine oil drain bolt, and then
tighten it to the specified torque.
Tightening torque:
Engine oil drain bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
11. Add the specified amount of recommend-
ed engine oil, and then install the engine
oil filler cap and tighten it.
Recommended engine oil:
See page 10-2.
Oil quantity:
Without oil filter cartridge replacement:
2.30 L (2.02 Imp qt, 2.43 US qt)
With oil filter cartridge replacement:
2.40 L (2.11 Imp qt, 2.54 US qt)
CAUTION:
_
In order to prevent clutch slippage
G
(since the engine oil also lubricates
the clutch), do not mix any chemical
additives. Do not use oils with a diesel
specification of "CD" or oils of a high-
er quality than specified. In addition,
do not use oils labeled "ENERGY
CONSERVING II" or higher.
Make sure that no foreign material en-
G
ters the crankcase.
_
12. Start the engine and warm it up for seve-
ral minutes. While warming up, check for
oil leakage. If oil leakage is found, turn
the engine off immediately and check for
the cause.
13. Turn the engine off, and then check the
oil level and correct it if necessary.
14. Install panel F.
8-17