Dear Customer, IMPORTANT INSTRUCTION AND ADVICE FOR THE USE OF ELECTRICAL APPLIANCES We thank you very much for choosing our The use of any appliance requires the compliance products. with some basic rules, namely: The instructions and advice included in this booklet are given to safeguard your safety and to use this do not touch the appliance with wet or damp –...
2 - USE OF THE HOB BURNERS Each burner is controlled by a gas tap assuring the ELECTRIC IGNITION opening and the closing of the gas supply. Make the symbols printed on the knob to match with To light the burners press the push-button marked the indicator on the control panel: (fig.
CHOICE OF THE BURNER It is important that the diameter of the pot be On the control panel, near every knob, there is a suitable to the potentiality of the burner so as not to diagram that indicates which burner is controlled by compromise the high output of the burners and that knob.
3 - GAS OVEN Attention: the oven too becomes very hot LIGHTING OF THEOVEN BURNER during operation. Keep children away. The cooker lidmust be kept open when oven is The cooker lid must be kept open when the gas in use. oven is inuse.
THERMOSTAT OVEN COOKING The numbers to 1 to10 printed on the knob (fig. 3.3) To cook, before introducing the food, preheat the oven indicate the increasing oven temperature value (see to the desired temperature (see table 3.4). table 3.4). To regulate the temperature, set the chosen number When the oven has reached the temperature, onto the control panel indicator (or onto the knob introduce the food, control the cooking time and turn...
Page 8
LIGHTING OF THE GRILL BURNER The cooker lid must b e keptopen when grill is in use. Open the oven door. Press thoroughly and turn clockwise the oven gas thermostat knob to set symbol (fig. 3.5). Put a flame to the right and left side of the burner for 2-3 seconds after the thermostat has been opened (fig.3.6).
ROTISSERIE This device is made up of: an electrical motor mounted on the rear part of the – oven; a stainless steel rod, equipped with a detachable – athermic grip and 2 recordable forks; a rod support to be inserted into the central rack –...
4 - GENERAL ADVICE Do not close the cooker lid when the burners or When the appliance is not being used, it is grill are still hot and when the oven is on or still advisable to keep the gas tap closed. hot.
5 - CLEANING AND MAINTENANCE Always switch the cooker off at the mains OVEN isolating switch before cleaning touching any electrical part. The oven must always be cleaned after every use, using suitable products and keeping in mind that its operation minutes highest...
Page 12
BURNERS SUBSTITUTIONOFTHEOVEN LIGHT They can be removed and washed with soapy water only. Before effecting any intervention on the They will remain always perfect if cleaned with electrical parts the appliance, products used for silverware. connection network m u s t After cleaning or wash, check that burner-caps and interrupted.
Page 13
Advice for the installer IMPORTANT Cooker installation, regulation and conversion to other gas types must only be carried out by QUALIFIED – TECHNICIANS. Failure to observe this rule will invalidate the warranty. The appliance must be installed in compliance with the laws in force in your country and in observation of the –...
INSTALLATION The walls of the units must not be higher than work top and must be capable of resisting t e m p e r a t u r e s 7 5 ° C a b o v e r o o m The cooker afford class “1”...
Page 15
CHOOSING SUITABLE SURROUNDINGS In the room chosen to accommodate the gas appliance, there must be an adequate natural draft to allow combustion of the gas. The natural draft must be produced directly by one or more vents made in the external walls and providing a total opening of at least 100 cm².
6 - GAS SECTION GASES INSTALLATION The appliance is predisposed and adjusted to operate with The gases used for the operation of cooking appliance may the gas indicated on the specifications plate appliedonto the begroupedby their characteristicsinto two types: appliance. L.P.G.
1 -GAS CONNECTION The rubber tube: must be as short as possible, without – The connection must be executed by specialized contractions or kinks; fitter according to the relevant standard. The fitting must be easy to inspect along its entire –...
Page 18
2 - REPLACEMENT OF THE TOP INJECTORS Each cooker is outfitted with small bag including a set of injectors for each kind of gas, whose diameter is marked on theinjector in centsof millimetre. Operations to be followed for the replacement of the injectors (worth for all k ind of gases): Lift the cooking top (fig.
Page 19
4 - ADJUSTMENT OF THE MINIMUM OF THE 3 - ADJUSTMENT OF PRIMARY AIR OF TOP TOP BURNERS BURNERS This operation is to be performed bearing in mind In passing from one type of gas to another, the gas that the flame may be as specified below, indipendently of the kind of gas.
Page 20
TABLE FOR THE CHOICE OF THE INJECTORS INCREASE OF AIR NECESSARY FOR GAS COMBUSTION (2m /h x kW) Burners Air necessary for combustion [m /h] Auxiliary (A) 1,80 Semi-rapid (SR) 3,10 Rapid (R2) 5,10 Rapid (R1) 6,10 Oven (Thermostat) 6,40 Grill 4,00 Cat:...
5 - REPLACEMENT OF THE OVEN Fig. 6.7 BURNER INJECTOR According to the type of gas, the oven injector must be similarly replaced, as stated on the table of the injectors, operating as follows: remove the oven bottom. – unscrew theburner fixing screw (fig. 6.7). –...
7 - PRIMARY A IR OF THEOVEN 8 - PRIMARY AIR OF THE GRILL BURNER BURNER With a screwdriver untighten the two screws (fig. With a screwdriver untighten the screw (fig. 6.12) 6.11) and move forward or backward to close or and turn the air ring to close or open the air flow, open the air flow, according to the “injector table”.
IMPORTANT 9 - REGULATINGOFTHEOVEN MINIMUM intervention regarding installation maintenance conversion To be effected operating as follows: appliance must be fulfilled with original light the oven taking the knob to position 10 (max). factory parts. – remove the knob and by a screwdriver, unscrew of The manufacturer declines any liability –...
7 - ELECTRICAL SECTION If the installation requires alterations to the domestic IMPORTANT: the cooker must be installed in electrical system or if the socket and appliance plug accordance with manufacturer’s are incompatible, call an expert. instructions. He should also check that the socket cable section is Incorrect installation, which...
ELECTRICAL CONNECTION REPAIRS To connect the supply cable: Before effecting any intervention on the Remove the screws securing the cover “A” on the electrical parts the appliance, – rear of the cooker (fig. 7.2). connection network must Feed the supply cable through the cable clamp “D”. interrupted.
Page 26
Description and illustrations in this booklet aregivenas simply indicative. The manufacturer reserves the right, considering the characteristics of the models described here, at any time and without notice, to make eventual necessary modifications for their construction or for c ommercial needs. Cod.