Symptom
No GPS symbols
are displayed
The vehicle
position is not
displayed
No voice guidance
Buttons in the
remote control
do not beep
No map displayed
(blank screen)
●GPS signals may not be received because of obstructions.
After removing the obstructions, the GPS signals can be
received.
●Has the GPS antenna cable been connected successfully?
a
Check the wiring by referring to [Wiring Check]
(
page 22).
●Check if the mode is set to the map mode.
a
Press
●Check if the volume control for the voice guidance is
adjusted to zero.
●Check if the vehicle is off the route.
a
Repeat the route search while checking the route guide
screen.
●Check if you are driving the vehicle in the wrong direction on
the route.
a
Repeat the route search checking the direction of the
destination.
●Check if [Beep] is set to [Off] (
●[Beep] may be set incorrectly during setup of an optional
display unit.
a
Set up the display unit correctly.
●Check if the disc is wet, scratched, or dewy.
Check point
page 43).
ENG
50
51