Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi WJE 1200
Summary of Contents for Zanussi WJE 1200
- Page 1 WASHER-DRYER WJE 1200 - WJE1300 USER MANUAL 132999891...
- Page 2 Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged.
-
Page 3: Table Of Contents
Contents Warnings Maintenance Door seal Disposal Bodywork Detergent dispenser drawer Tips for environmental protection 5 Drain filter Water inlet filter Technical specifications Emergency emptying out The dangers of freezing Installation Unpacking Something not working? 27-28 Positioning Water inlet Water drainage Electrical connection Your new washer-dryer Description of the appliance... -
Page 4: Warnings
Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation • Use only the recommended quantities of fabric softener. An excessive amount could damage the • All internal packing must be removed before using laundry. -
Page 5: Disposal
Child safety • Make sure that children or pets do not climb into the drum. • Children are often not aware of how dangerous • When the appliance is to be scrapped, cut off the electrical appliances can be. When the machine is electrical supply cable and destroy the plug with working, children should be carefully supervised the remaining cable. -
Page 6: Technical Specifications
(WJE 1300) kg (WJE 1300) Delicates 2.5 kg (WJE 1200) kg (WJE 1300) Woollens SPIN SPEED 1200 rpm max. (WJE 1200) 1300 rpm max. (WJE 1300) POWER SUPPLY VOLTAGE/FREQUENCY 220-230 V/50 Hz TOTAL POWER ABSORBED 2200 W MINIMUM FUSE PROTECTION... -
Page 7: Installation
Installation Positioning Install the machine on a flat hard floor. Unpacking Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the All transit bolts and packing must be removed machine does not touch the wall or other kitchen before using the appliance. -
Page 8: Water Drainage
Water drainage Electrical connection This machine is designed to operate on a 220-230 V, The end of the drain hose can be positioned in three single-phase, 50 Hz supply. ways: Hooked over the edge of a sink using the plastic Check that your domestic electrical installation can hose guide supplied with the machine. -
Page 9: Your New Washer-Dryer
Your new washer-dryer This new washer-dryer meets all modern needs for effective treatment of laundry with low water, energy and detergent consumption. • The possibility of selecting the temperature, spin speed and all the options offered by this machine gives you truly “customised”... -
Page 10: Use
Control panel 1 ON/OFF button 4 TEMPERATURE button Press this button to switch the machine on. Press this button repeatedly to increase or decrease Press the ON/OFF button again to switch the the temperature, if you want your laundry to be washed machine off. - Page 11 To complete the cycle, choose one of the following 7 Automatic Drying button options: By means of this button you can choose the required • Draining and spin: degree of drying for cottons and synthetics: - Press the START/PAUSE button .
- Page 12 • Duration of washing programme in hours • Delay start, a time value indicated in hours and selected by means of the relevant button. and minutes, after you have selected a programme. The delay time is displayed for 3 seconds, then the While the programme is running (after you have duration of the selected programme reappears.
- Page 13 Example: 10 START/PAUSE button In this case, only the This button has three functions: spin (at the speed • Start: after you have selected the desired provided for the programme and options, press this button to start selected type of fabric) the machine.
- Page 14 12 DELAY button This button makes it possible to delay the starting of the programme by up to 24 hours. The delay you have selected is shown on the display for about 3 seconds; afterwards, the duration of the programme reappears.
-
Page 15: Washing Hints
Laundry weights Washing hints The following weights are indicative: bathrobe 1200 g Sorting the laundry napkin 100 g Follow the wash code symbols on each garment quilt cover 700 g label and the manufacturer’s washing instructions. Sort the laundry as follows: sheet 500 g whites, coloureds, synthetics, delicates, woollens. -
Page 16: Detergents And Additives
Ink: depending on the type of ink, moisten the fabric Quantity of detergent to be used first with acetone (*), then with acetic acid; treat any The type and quantity of detergent will depend on residual marks on white fabrics with bleach and then the type of fabric, load size, degree of soiling and rinse thoroughly. -
Page 17: Drying Hints
Sort of laundry (dry weight) Duration of the drying cycle Linen and cottons 2.5 kg (WJE 1200) The drying time can vary according to kg (WJE 1300) • the final spin speed; Synthetics • the required degree of drying (extra dry, store dry or iron dry);... -
Page 18: International Wash Code Symbols
International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash Max. wash Max. wash Max. wash Max. wash temperature temperature temperature temperature 95°C 60°C 40°C 30°C Hand wash Do not... -
Page 19: Operating Sequence
4. Switch the machine on Operating sequence To switch the machine on, press the ON/OFF button : the mains-on light comes on. The display will show three blinking dashes or a Wash only blinking zero. Before washing your first load of laundry, we recommend that you run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. -
Page 20: Select The Delay Time
9. Select the DELAY TIME 6. Select the temperature Before you start the programme, if you wish the Press the TEMPERATURE button if you wish to starting to be delayed, press the DELAY button select a temperature value different from the one repeatedly, or keep it pressed, to select the desired proposed by the machine. -
Page 21: End Of Programme
If it is necessary to drain the water in order to change 14. End of programme the programme in progress, proceed as follows: At the end of the programme, the machine stops • PAUSE the machine by pressing the automatically, gives an audible signal, and displays a START/PAUSE button;... -
Page 22: Drying Only
Drying only Automatic washing and drying (NON-STOP programme) Warning! Do not exceed the maximum laundry loads: Warning! For NON-STOP programmes, it is also - 2.5 kg or 3 kg depending on the model for linen essential not to exceed the maximum load sizes of and cottons 2.5 kg or 3 kg for cotton and 2 kg for synthetics. -
Page 23: Washing Programmes
The data refers to the highest temperature provided for each programme and for cotton to a wash load of 5 kg for model WJE 1200 and 5.5 kg for model WJE 1300. -
Page 24: Timed Drying
Synthetics and ironing mixed fabrics (jumpers, blouses, underwear, household linen) 2.5 kg 1200 Cotton and linen Iron dry 3 kg 1300 (sheets, tablecloths, Suitable for 1200 shirts, etc.) ironing 1.5 kg 1300 * for WJE 1200 ** for WJE 1300... -
Page 25: Maintenance
Maintenance 1. Door seal Detergent can also accumulate inside the drawer recess: clean it with an old toothbrush. Refit the Check from time to time the door seal and eliminate drawer after cleaning. eventual possible objects that could be trapped in the fold. -
Page 26: Water Inlet Filter
5. Water inlet filter The dangers of freezing If you notice that the machine is taking longer to fill, If the machine is exposed to temperatures below check that the filter in the water inlet hose is not 0°C, certain precautions should be taken. blocked. -
Page 27: Something Not Working
Something not working? Problems which you can resolve yourself. During machine operation it is possible that one of the following alarm codes appears on the display: - E10: problem with the water supply If at the end of the programme the alarm code EF0 is - E20: problem with water draining displayed this means that the drain filter is clogged. - Page 28 Problem Possible cause • Spinning starts late or the • The electronic unbalance detection device has cut in because the laundry is not evenly distributed in laundry is not spun enough: the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume.