Battery Page; Ups Status Page - GE Digital Energy 1018959 Operating Manual

3.3.2 Battery page

The Battery page shows the following information.
Parameter Name
Battery Status
Seconds On Battery
Estimated Minutes Remaining
Estimated Charge Remaining
Battery Voltage
Battery Current
Battery Temperature
Battery Ripple

3.3.3 UPS Status page

The UPS status page shows the following information for each of the input / output / bypass lines.
Parameter Name
Frequency
Voltage
Current
Power / True Power
Load %
Volt min
Volt max
Also the following information is presented:
Parameter Name
Input Line Bads
Output Source
Modifications reserved
OPM_CNT_SNM_BAS_CRD_1GB_V014.doc
Description
The current status of the battery:
1 – unknown
2 – normal The remaining run-time on batteries is greater than
the UPS low battery time (ref. UPS Config page)
3 – low The remaining run-time is less than or equal the UPS low
battery time (ref. UPS Config page)
4 – depleted The battery would be unable to sustain the load, if mains
power is lost
The time elapsed since the UPS switched to battery power (in seconds)
An estimate of the remaining run-time on batteries, under present load
conditions (in minutes)
An estimate of the remaining battery charge (in percentage – 100% is full
charge)
The present battery voltage (in Volts)
The battery flowing from/to the battery (in Amperes)
The ambient temperature of the UPS batteries (in °C)
The RSM ripple on the DC link (in Vrms)
Description
Line frequency (in Hertz)
Line RMS voltage (in Volts)
Line RMS current (in Amperes)
Line True Power (in Watt)
The power capacity presently being used (percentage)
Lowest input voltage in the present time-period (in Volts)
Lowest input voltage in the present time-period (in Volts)
Description
Number of times the mains input went out-of-tolerance since UPS start-up
The present source of the output power
Note: none means there is no output power
[Output only]
[Input only]
[Input only]
Page 29/69
Operating Manual SNMP/Web Adapter