Toshiba Hi Speed Port ReplicatorII_UM.fm Page 7 Thursday, January 13, 2011 2:00 PM
Back view
The following illustration shows the back of the Toshiba Hi-Speed Port ReplicatorII. For a description of
each component, please refer to the table below.
Microphone jack
Network port
USB 2.0 port
(Sample Illustration) The back of the Toshiba Hi-Speed Port ReplicatorII
NOTE
When your computer is docked in the port replicator, the following ports on the computer, if present,
are not operational:
■
Network port
■
Monitor ports (RGB)
■
Audio ports (Microphone jack or Headphone/Line out)
If you want to use the docked computer's audio ports, you can enable them as shown in "configuring
audio ports" section. Otherwise, use the ports on the port replicator instead.
Component
Microphone jack
Line out
(Headphones,
Speakers)
LAN active light
Network port
User's Manual
Line out (Headphone, Speakers)
LAN active light
LAN connected light
Serial port
USB 3.0 port
RGB monitor port
Description
A standard 3.5 mm mini jack for mono audio input from a microphone.
A standard 3.5 mm mini jack for audio output to speakers,
a headphone or headset, or other audio out devices.
Glows orange when the computer is exchanging data with the
network.
Connection point for a network cable.
Supports:
*Ethernet (10 megabits per second, 10BASE-T)
*Fast Ethernet (100 megabits per second, 100BASE-T)
*Gigabit Ethernet (1000 megabits per second, 1000BASE-T)
Note: Gigabit Ethernet support is only available if your computer
model also supports it.
TOSHIBA Hi-Speed Port Replicator II
DisplayPort
Port Replicator lock switch
Security lock slot
DC-IN (19V)
HDMI port
Slider
EN-7