Whirlpool 8178501A Manual page 18

7. To remove the core board:
a) Remove the wire connectors from P1,
P2, P3, P5, P6, and P7.
b) Unclip the tabs at the top of the board,
and remove the shield and board from
the dispenser housing. NOTE: If the
tabs become damaged, secure the
board with two screws at the indicated
top corner locations.
Screw Hole
P6
P7
P5
Board Orientation Notch
Core Board Tabs
Core Board
Screw Hole
P1
P2
P3
8. To remove an ice or water pad switch:
a) With the back of the dispenser cover
assembly facing up, press the release
tab in on the wire connector, and pull the
connector off the user interface board
pins.
Water & Ice Pad
Switch Connectors
Water
Back Of Dispenser
Cover Assembly
b) Press in on the release button, and slide
the pad switch clips off the dispenser
cover assembly.
Slide Pad Switch Up
To Disengage Clips
c) Remove the pad switch assembly.
Pad Switch
Assembly
3-4
Ice
Release
Buttons