Yamaha Disklavier E3 Operation Manual page 149

Chapter
12
Other Settings
5
Press [PLAY/PAUSE] to start the update.
The update process of the first module takes approximately 3
minutes.
MC v2.20
DO NOT REMOVE DISK!
When the update of the first module completes, the following
confirmation message appears.
Confirmation message of the second module
v2.10
CTRL-SURE?
Press [PLAY/PAUSE] to start the update of the second module.
The update process of the second module takes approximately 3
minutes.
A total of four modules needs to be updated. Repeat this step to
complete the update.
Confirmation message of the third module
v2.01
APE -SURE?
The update process of the third module takes approximately 2
minutes.
Confirmation message of the fourth module
v2.10
CSP -SURE?
The update process of the fourth module takes approximately 2
minutes.
The closing screen appears when the update for all modules
completes.
OMPLETE
Turn OFF,Turn ON again!
6
Restart the Disklavier.
130
 v3.00

v3.00
(PLAY,STOP)
 v3.00
(PLAY,STOP)

v3.00
(PLAY,STOP)
Important:
DO NOT turn off this unit during
update.
Important:
Be sure to update all the modules.