Summary of Contents for Husqvarna 42" Collection System
Page 1
Operator and Parts Manual Collection System 42" and 48" / 966805002...
Page 2
KNOW YOUR BLOWER SYSTEM CONGRATULATIONS on the purchase of a new collection system. It has been designed, engineered READ THIS OPERATION MANUAL AND SAFETY and manufactured to give you the best possible RULES BEFORE ASSEMBLING OR OPERATING dependability and performance. YOUR BLOWER SYSTEM.
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS DANGER ! THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. GENERAL OPERATION • Keep machine free of grass, leaves or other •...
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS CHILDREN • Keep machine free of grass, leaves, or other debris buildup. Clean oil or fuel spills. Allow Tragic accidents can occur if the operator is not machine to cool before storing. alert to the presence of children.
Page 6
ASSEMBLY BAGGER SUPPORT ASSEMBLY Draw Bar B Draw Bar A 1. Remove the upper bolts on each side of the 1. Slide the flanges of the support assembly in the drawbar and replace them with the shoulder bolts slots in the drawbar. supplied with the collection kit.
Page 7
ASSEMBLY DECK ADJUSTMENT MOUNTING BLOWER ASSEMBLY 1. Locate the rear adjustment nut on the discharge 1. Remove the discharge chute from the deck. side of the deck. To assure the right tighteness, 2. Lower deck to the lowest cutting position. mark the front side of the nut.
Page 8
ASSEMBLY INSTALLING DRIVE BELT INSTALLING BELT COVERS 1. Place the deck belt shield on the deck over the NOTE: The kit provides parts for both the 42" and 48". drive pulley and secure with hardware removed Refer to the parts list on page 14 for the correct belt for from steel belt shield.
Page 9
ASSEMBLY INSTALLING CHUTE SUPPORT MOUNTING COVER ASSEMBLY 1. Position upper chute support against bagger inlet, NOTE: Assistance from another person may ease flush at outer edges. See Illustration. mounting the cover assembly to mower. 1. Lift and rotate cover to align the cover brackets 2.
Page 10
ASSEMBLY INSTALLING SPACER PLUGS CONTAINER INSTALLATION 1. Remove plastic end caps from the center two bag 1. Install containers on support frame, overlapping support arms. Fully insert spacer plugs into the containers at center tube. ends of the support tubes. It may be necessary NOTE: One container should always overlap the other to tap the spacers into place with a hammer or container at the center tube.
OPERATION TIPS FOR IMPROVED BAGGING Follow the mower operation instructions in you mower • If the grass catcher fails to pick up cut grass operator’s manual. or leaves, it is an indication that clogging has When operating your grass catcher on a lawn where occurred in the system or that the grass catcher grass and leaf bagging equipment has not been containers are full.