Hitachi N 5008AC2 Instruction And Safety Manual page 16

English
2) the Stapler is always held firmly against
the workpiece.
If staples are driven too deep or shallow into
the workpiece, adjust the stapling in the
following order.
1 DISCONNECT
STAPLER.
Push lever
piece
2 To adjust the driven-in depth of a staple,
loosen the screw that secures a push
lever piece.
If the staple is driven in deeply, adjust
the push lever piece to "down", and if
it's driven in shallowly, adjust the push
lever piece to "up".
Too deep
Too shallow
3 Tighten the screw to fasten the push lever
piece when a suitable position is reached
for a stapling test.
4 Connect the air hose.
ALWAYS WEAR EYE PROTECTOR.
Perform a stapling test.
AIR HOSE FROM
Screw
14
Disconnect
air hose
5 DISCONNECT
STAPLER.
6 Choose a suitable position for the push
lever piece.
— 16 —
AIR HOSE FROM