Panasonic Easa-Phone VA-824 Installation And Programming Manual page 18

Connection of SMDR
-
This system enables the output from KSU call record data for a telephone (duration of call, etc.) through the RS-232C inter-
face.
These data are output by the printer connected to KSU.
Programming is necessary for outputting from KSU. (See page 48)
0
Connection of printer
Connect the RS-232C connector of KSU and the printer (KX-PI 08Oi) by means of the RS-232C cable. Note that because
the printer (KX-P1080i) uses a parallel interface, KX-PIID is also necessary. See the manual for the RS-232C interface
board (KX-PI 1 D) for how to mount KX-PI 1 D to the inside of the printers.
l
Explanation of call record output data
The following is an explanation concerning the output format and display contents for call record data.
l
Outputting data forma?
(Call record data with title)
TIME DURAT. C COr: DIALED NO. TEL4
ACCT f;
uuuuxx:xxux:xx.xuxuuuxuuuuuxxxxx-xxx-xxxxuuuxxuuuuxxxxx
(Call record data only)
uxxuxx
HH
Month Da"
U : Blank X : Data
l
Display Contents
Display items
Call finish time
Call duration
Contents
Displays in hours/minutes (24 hour system)
Display duration of call from start to finish in hours/minutes/seconds
(1 digit per 6 second interval).
Condition code
CO/PBX line number
Dial number
Extension number
Account code
Displays use contents regarding CO/P8X line by the following letters or Blank.
D: When call has lasted over 10 hours.
L : For conference call.
I : For incoming call
Blank: For outgoing call.
* The priority sequence for the condition code display is D > L > I > Blank.
Displays the line numbers used (1 to 8)
When dialing, displays the number moving from right to left to a maximum
of 15 digits. Note that for display "*" is converted to I'>" and ':#'I to "<,'.
Displays the extension number used (10 to 33).
Displays the account code input by the caller moving from left to right to a
maximum of 5 digits.