Creating A Management Access Control List; Figure 18: Management Acl; Table 28: Management Acl - D-Link DWL-8600AP Administrator's Manual

D-Link UAP
C M
REATING A ANAGEMENT
You can create an access control list (ACL) that lists up to five IPv4 hosts and five IPv6 hosts that are authorized to access
the Web-based AP management interface. If this feature is disabled, anyone can access the management interface from any
network client by supplying the correct AP username and password.
To create an access list, click the Management ACL tab.
Field
Management ACL Mode
IP Address (1–5)
IPv6 Address (1–5)
Note: After you configure the settings, click Apply to apply the changes and to save the settings.
Page 66

Creating a Management Access Control List

A C
CCESS

Figure 18: Management ACL

Table 28: Management ACL

Description
Enable or disable the management ACL feature. At least one IPv4 or IPv6 address
should be configured before enabling Management ACL Mode. If enabled, only the IP
addresses you specify will have Web, Telnet, SSH, and SNMP access to the
management interface.
Enter up to five IPv4 addresses that are allowed management access to the AP. Use
dotted-decimal format (for example, 192.168.10.10).
Enter up to five IPv6 addresses that are allowed management access to the AP. Use
the standard IPv6 address format (for example 2001:0db8:1234::abcd).
Software User Manual
L
ONTROL IST
12/10/09
34CSFP6XXUAP-SWUM100-D13