Hitachi GD-2000 Installation Manual page 9

GD-2000 Manual 6/18/98 5:25 PM
9) DEVICE CONFIGURATION JUMPER
10) ATAPI INTERFACE CONNECTOR
11) POWER SUPPLY CONNECTOR (DC Input)
HARDWARE
Page 9
This connector is used to set operation modes such as Master, Slave
and CSEL
6 4 2
5 3 1
ATAPI bus connection (40 pin)
For connecting the power supply cable.
Circuit Board
• DVD-ROM drive
• Interface card
• Interface cable
• Power supply cable
• Mounting screws
Device is
Master
Device is
or
Slave
(default setting)
Cable
Select
+5V GND +12V
Installation Requirements
GD 2000 DVD ROM M l P