Channel Manager; Signal Meter; Auto Channel Scan - Hitachi 42HDT79 Operating Manual

Channel Manager

Channel Manager
Select CHANNEL MANAGER to set your Antenna
options, run Auto Channel Scan, Check Signal Meter
and Set Channel List.
1. Press CURSOR PAD
buttons to highlight function.
2. Press the SELECT button or CURSOR PAD
select.

Signal Meter

Select SIGNAL METER when using an indoor or outdoor
antenna. This feature will show the signal strength and
peak values of the Antenna signal to help you adjust your
antenna to optimize signal reception.
Use the CURSOR PADS and the SELECT button to
highlight and select CLOSE to exit.
NOTE: The Signal Meter will not be available (grayed
out) when watching analog channels.

Auto Channel Scan

This feature will automatically store active Analog and
Digital channels in Auto Channel Scan memory.
Use the CURSOR buttons
1.
AIR, CABLE (1) or CABLE(2) source.
2. Press the CURSOR buttons
START or RESET option.
3. Press the SELECT button to select.
NOTE: 1. When a CableCARD is installed, Auto
Channel Scan will not be available since
channels will be fixed based on what was
agreed upon by you and your cable
operator.
2. If certain channels are poor or not possible
in cable(1) mode, set cable source to cable(2)
by using the CURSOR buttons
56
, or CHANNEL WHEEL
to
or to highlight
or to highlight the
or .
Video
Audio
TV Guide On Screen
Channel Manager
Locks
Timers
Setup
Power Swivel
SEL
Move Select
Channel Manager
Signal Meter
OR Auto Channel Scan
Channel List
SEL
Move Select
Channel Manager
Signal Meter
OR Auto Channel Scan
Channel List
SEL
Move Select
Channel Manager
Signal Meter
3- 1
Channel
91
Strength
91
Peak
SNR 10
Close
SEL
Move Return
Channel Manager
Signal Meter
Auto Channel Scan
Channel List
Move SEL Select
Channel Manager
Auto Channel Sc an
OR
Air
Source
Auto Channel Sc an
Start
Move SEL Return
Reset