Hitachi ALPHA SERIES L32A404 Owner's Manual page 8

How To Install Your New Hitachi LCD Television
WALL MOUNTING SETUP
STEP (1) : REMOVE THE STAND BASE FROM THE LCD TELEVISION
In order to remove the stand from the TV safely, please put the TV set on a soft and flat surface (blanket, foam, cloth, etc.)
to prevent any damage; then remove the screws as shown below (For model L42A404, there is one more screw under the
cover) to separate the TV from the Table Top Stand. Now the Stand can be separated from the TV. Useful dimensions for
the WALL MOUNT assembly are illustrated on page 39 and page 40.
L32A404
STEP (2) : INSTALL THE WALL MOUNT BRACKETS ON THE LCD TELEVISION USING 4 SCREWS.
For Wall Mount assembly, please refer to the Installation Manual
of the Wall Mount Unit.
CAUTION
STEP (3) : TIPS TO CONSIDER FOR THE LOCATION OF THE LCD TELEVISION.
More than
30 cm (1').
More than
10 cm (4").
CAUTION
installation of this LCD Display Panel using wall mounting brackets/devices be performed only by a qualified and experienced television
installation technician who has completed a thorough evaluation of:
a) the weight-bearing strength and stability of the intended wall mount surface.
b) the weight-bearing strength and compatibility of the intended wall mount brackets/device.
8
(a)
4 Screws ((a) M4 and
(b)
(a)
(b) tapping screws).
(b)
Do not mix please.
Screw mounting holes (4 locations) for use
with a wall mount bracket.
DO NOT reuse the original screws that
were in these screw mounting holes or the
screws removed in STEP (1) above, as
such screws are not long enough to properly
secure the TV to the wall bracket.
Please refer to example at right and caution
below to determine proper screw length.
Wall Mount Brackets
Insertion length (B) of the screws must be within 8.5~10.5 mm. If the length is less than 8.5 mm, the TV's
weight cannot be maintained. If the length is more than 10.5 mm, a space is created between the Wall
Mount Bracket and the LCD Television. This insertion length is very important.
Keep
more than
2 cm (0.8")
away from
the wall.
Although this LCD Display Panel can be installed using a variety of third party wall mounting brackets/devices,
such third party brackets/devices have not been tested or approved by Hitachi for use or compatibility with
this LCD Display Panel. Accordingly, Hitachi accepts no responsibility or liability for any injuries or property
damage resulting from the use of such third party brackets/devices. Hitachi strongly advises that any
M4 screws (4 pcs)
L42A404
CAUTION
• If you purchased a Wall Mount bracket, it is recommended that you ask
for a professional installation.
• This LCD unit features an advanced ventilation system configured for
vertical installation. A knowledgeable and experienced professional
technician can perform other mounting or installation orientations (e.g.,
horizontal, tilted) provided that you specifically inform the technician of
the unit's specialized ventilation needs. Call 800.HITACHI for additional
info and guidance.
1 Screws (M4).
Stand Base
Screw Length (A)
Insertion Length (B)
Spring Washer (C)
Plane Washer (D)
Wall Mount Bracket (E)
Example :
A = B+C+D+E
A: 13.5~15.5 mm.
B: 8.5~10.5 mm.
C: 1 mm.
D: 1 mm.
E: 3 mm.
The screw type :Thread ISO M4 (Metric type,
do not use Standard type).
• Do not block the ventilation holes. In addition
please keep a certain distance around the
TV and make sure not to obstruct ventilation.
Blocking the ventilation holes may cause fire or
defect.