Connecting A Printer; Connecting Usb Devices - Hitachi SA200 Series Manual

lonestar.boo : sa200.fm Page 49 Friday, March 6, 1998 10:53 AM

Connecting a Printer

Follow these instructions to connect a printer:
1.
2.
3.
4.
5.
6.

Connecting USB Devices

You can connect peripheral devices that meet USB specifications
to your SA200.
Follow these steps to connect a USB device:
1.
2.
3.
4.
SA200
4 Connecting and Installing Optional Devices
Locate the parallel port at the rear of your laptop. Refer
to Figure 3 on page 7.
Connect the printer's 25-pin male connector to the
parallel port at the rear of your laptop.
If necessary, attach the printer cable to your printer.
Tighten any retaining screws.
Turn on the printer and any other peripheral devices you
have connected to the laptop.
If necessary, run the BIOS Setup program to configure
the parallel port to properly respond to your system.
Configure your printer in Windows 95. Refer to both
your Windows 95 documentation and your printer
documentation for detailed information.
Locate the USB port on the rear of your laptop. Refer to
Figure 4 on page 8 for details.
Connect the USB cable to the USB port.
Connect the other end of the USB cable to your USB
device.
Follow the instructions provided with the device for
configuration and usage. If your laptop is turned off, turn
it on.
49