Rear Panel Jacks; Monitor Out - Hitachi 42V52 Operating Manual

Antenna Input/Output
The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A input can
be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture. (ANT B cannot be displayed as a
sub-picture.) The antenna output labeled "TO CONVERTER" allows the ANT A connection to pass directly to a different source
such as a cable box, only when ANT B is displayed as a main picture.
Audio/Video Inputs 1, 2, 3 and 4
By using the INPUTS button and CURSOR buttons of the remote control you can select each video source. Use the audio and video
inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (If you have mono sound, insert
the audio cable into the left audio jack.)
NOTE: You may use VIDEO or S-VIDEO inputs to connect to INPUT 3 and 4, but only one of these inputs may be used at a
time.

MONITOR OUT

These jacks provide fixed or variable audio and video signals which are used for recording. Use the S-VIDEO Output for high
quality video output (see page 65).
S-VIDEO Inputs 3 and 4
Inputs 3 and 4 provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability.
Component: Y-P P Inputs
B R
Inputs 1 and 2 provide Y-P
use composite video signal for both inputs.
NOTES: 1. Do not connect composite VIDEO and S-VIDEO to Input 3, 4 or 5 at the same time. S-VIDEO has priority
over VIDEO input.
2. Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to
the TV's P B input and the components R-Y output to the TV's P R input.
3. Your component outputs may be labeled Y-C B C R . In this case, connect the component C B output to the TV's
P B input and the component C R output to the TV's P R input.
4. It may be necessary to adjust TINT to obtain optimum picture quality when using the Y-P B P R inputs (see page 38).
5. To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the Y-P B P R jacks.
6. Input 1 and Input 2 (Y/VIDEO) can be used for composite video and component video input.
ANT A
TO
CONVERTER
ANT B
MONITOR OUT INPUT 4 INPUT 3
S-VIDEO
VIDEO
(MONO) (MONO)
L
TV AS CENTER
AUDIO
R
AUDIO
TO HI-FI
P jacks for connecting equipment with this capability, such as a DVD player or Set Top Box. You may
B R
HDMI 1
INPUT 2 INPUT 1
Y/ Y/
VIDEO VIDEO
P P
B B
P P
R R
(MONO) (MONO)
RS232C
1 2 3 4 5
6 7 8 9
10

REAR PANEL JACKS