Rear Panel Jacks; Monitor Out - Hitachi 46W500 Operating Manual

REAR PANEL JACKS

Antenna Input/Output
The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A input can
be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture (ANT B cannot be displayed as a
sub-picture). The antenna output labeled "TO CONVERTER" allows the ANT A connection to pass directly to a different source
such as a cable box, only when ANT B is displayed as a main picture.
Audio/Video Inputs 1, 2, 3 and 4
The VID1~VID4 buttons will select each video source each time they are pressed. Use the audio and video inputs to connect
external devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (if you have mono sound, insert the audio cable
into the left audio jack.)
NOTE: You may use VIDEO or S-VIDEO inputs to connect to INPUT 3 and 4, but only one of these inputs may be used at a
time.

MONITOR OUT

These jacks provide fixed audio and video signals which are used for recording. Use the S-VIDEO Output for high quality video
output.
NOTES: 1. S-VIDEO Output may be used for recording, only when the input is of S-VIDEO type.
2. When in DVD mode, MONITOR OUT will not be available.
AUDIO TO HI-FI Output
These jacks provide variable audio output to a separate stereo amplifier. With this connection, the audio to the stereo can be
controlled by the television's main volume.
S-VIDEO Inputs 3 and 4
Inputs 3 and 4 provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability.
P P Y
R B
ANT A
INPUT 1
TO
R (MONO)/L
CONVERTER
AUDIO
P
P Y/VIDEO
B
R
ANT B
INPUT 2
R (MONO)/L
AUDIO
R (MONO)/L VIDEO
INPUT 3
AUDIO
R (MONO)/L VIDEO
TO HI-FI
INPUT 4
L
R L VIDEO
MONITOR
R
OUT
"No DVD Out"
AUDIO
DVI-HDTV
S-VIDEO
S-VIDEO
OPTICAL OUT
Digital Audio
S-VIDEO
11