Table of Contents
Advertisement
Chapter 3 Operation
How to use the AIT Drive
This chapter describes how to use the AIT drive, and how to handle data
cartridges.
1
Press the POWER switch on the front panel.
The POWER indicator should light, and the TAPE MOTION,
CLEANING REQUEST, and REPLACE TAPE indicators should blink
as the self-test is performed.
2
When the three indicators stop blinking, open the dust cover and insert a
data cartridge as shown below. The TAPE MOTION indicator lights.
3
Computer software controls the reading and writing of tapes. While
reading or writing, the TAPE MOTION indicator blinks.
4
Close the dust cover.
Caution
Do not touch the rear of the drive unit during operation, to prevent the
possibility of mulfunction.
19
Chapter 3 Operation
Advertisement
Table of Contents
