Preparation Before Operation - Hitachi CC14SE OM Instruction And Safety Manual

Hitachi cut-off machine owners manual
Table of Contents

Advertisement

Available languages

Available languages

English

PREPARATION BEFORE OPERATION

Make the following preparations before operating the power tool:
1. Installation
The machine may be bolted (2 bolts) down to a level location using the bolt holes in the
base.
2. Extension Cord.
Ampere rating
(on nameplate)
Ext. cord length
25 ft
(7.5 m)
50 ft.
(15 m)
100 ft.
(30.5 m)
NOTE: The lower the wire size number, the heavier the wire, and the farther it will carry
current without a voltage drop.
WARNING:
3. Take off the chain.
As the movable part is pulled down by a chain when shipping out, slightly push the
handle down and take off the chain from the handle.
10
12.1 to 16.0
Wire gauge size
2
A.W.G (mm
)
14 A.W.G
2
(2.0 mm
)
12 A.W.G
(3.5 mm
2
)
Not
recommended
Never connect this unit to an electrical power source until all operating
instructions have been read and understood.
To use the power tool when no suitable power
source is nearby, use an extension cord of
suitable size to ensure safety, and to prevent
power loss and overheating.
Determine from the accompanying table the
required extension cord wire size.
Check power cord and extension cords for loose
or exposed wires and damaged insulation,
before using.
Repair or replace as needed, before using the
power tool.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cc 14se

Table of Contents