English
If you are using a ductless configuration, skip this step.
In "Vertical Discharge" or "Horizontal Discharge" mode, please reinsert baffle
into air chute (as shown)
Preparation of Electrical Connections
Note: If replacing an existing hood, the electrical cable may need to be
re-routed to the desired position.
1. Determine the location of the electrical cable that will connect to
the range hood (Fig.2). The preferred location for the electrical
connector, vertical or horizontal, will depend on the existing
installation or ease of routing wiring. All electrical connections must
comply with local and national codes. Transfer the location of the
selected range hood knockouts to the bottom of the cupboard or
onto the wall, then cut or drill a hole to allow for clearance of the
electrical cable clamp. Be careful not to cut into any hidden utilities,
such as electrical wires.
2. Once you have planned your ducting and electrical installation,
remove the appropriate electrical knockouts on the back or top of
the range hood, attach the damper frame and install a standard
electrical cable clamp.
7
fig. 2