Change The Master Pin; Change The Recall Time; Reset The Unit - AEG ECLIPSE 10 User Manual

13.10 Change the Master PIN

The Master PIN is used for registration/deregistration of handsets and for accessing the answering machine
remotely. The default Master PIN number is 0000. The maximum length of the Master PIN is 8 digits.
Note: If you forget your PIN code, you can reset it to its default 0000 using a handset Reset.
From the home screen, press
Press to "SETTINGS" and then press
Press to select "CHANGE PIN".
Enter the current Master PIN and then press
>The PIN will be shown as asterisks (*) on the screen as you enter them.
Enter the new PIN and then press
>A confirmation tone is played.
Press to return to the home screen.
13.11 Set the First Ring (for Additional Handsets Only)
If you have subscribed to Caller Line Identification service and do not wish to hear the phone ring before
the caller identification is displayed, you can set the "FIRST RING" to "OFF".
From the home screen of your additional handset, press
Press to "ADVANCED SET" and then press
Press to "FIRST RING" and then press
Press to select "ON" or "OFF" and then press
>A confirmation tone is played.
Press to return to standby mode.

13.12 Change the Recall Time

You may need to press
connected to a PBX or using certain network services. You should normally leave the Recall Time at its
default setting, Short (100ms). However, it can be changed to Medium (270ms) or Long (600ms) if your
telephone is connected to a PBX that requires a different recall time.
From the home screen, press
Press to "SETTINGS" and then press
Press to "RECALL TIME" and then press
Press to select "SHORT", "MEDIUM" or "LONG" and then press
>A confirmation tone is played.
Press to return to standby mode.

13.13 Reset the Unit

You can reset your phone to its default settings with this feature.
Note: Upon reset, all your personal settings, call log and redial list entries will be deleted and the phone will
return to its default settings, including the Master PIN. However, your phonebook will remain unchanged
after reset and any recorded messages will remain unchanged, while all other settings will be reset.
From the home screen, press
Press to "SETTINGS" and then press
Press to select "RESET" and then press
Press again to confirm.
>A confirmation tone is played and the unit is reset to its default settings.
.
to confirm.
to send a Flash signal (also called Recall or Timed Break Recall) if you are
.
.
to select.
to confirm.
.
to select.
to select.
to confirm.
to select.
to select.
to select.
to select.
to confirm.