Husqvarna 371K Workshop Manual Supplement page 11

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
CUTTING EQUIPMENT
Remove the pulley from the cutting arm.
Drive out the shaft with the aid of a drift
and hammer.
NOTE!
If it is only necessary to remove
the spacer and flange washer,
this can be done by inserting
two screwdrivers between the
flange washer and the disc
guard and prising upwards.
Remove the bolts, cover plate,
the friction washers and the
disc guard.
Remove the bolts, cover plate, friction
washers and disc guard.
Remove the ball-bearings from their
housing in the cutting arm.
www.mymowerparts.com
Lock the pulley using a suitable drift
and unscrew the bolt that holds the
pulley. Lift off the pulley and the washer
that is between the pulley and the ball-
bearing.
Place a suitable socket underneath the
cutting arm and drive out the shaft
using a drift and hammer.
Lift off the spacer and flange washer.
NOTE!
If it is only necessary to remove
the spacer and flange washer,
this can be done by inserting
two screwdrivers between the
flange washer and the disc
guard and prising upwards.
Then prise off the flange washer
and spacer.
Remove the three bolts, cover plate,
plastic washer, rubber washer and disc
guard.
Heat the cutting arm to around 150ºC
using a hot air gun and remove the
bearings. If necessary use a suitable
drift (505 38 17-09) and hammer to tap
them out.
11
English –