Epson WristableGPS SS-700 User Manual page 50

Chapter 4
Using the Interval Function
Measure
Press to start interval measurements.
is displayed on the measurement screen.
When the sprint distance (or sprint time) has passed,
an alarm sounds and the rest screen is automatically
displayed.
Also, when the rest distance (or rest time) has passed, an
alarm sounds and the sprint screen is displayed.
The number of exercise routines increases by one.
· If you press
to sprint again. This also increases the number of exercise routines.
· If no GPS signal is being received (when the
change between sprinting and resting even if you reach the set time. Make sure
you are in an environment where the GPS signal can be easily received without
any obstructions overhead, and check that the GPS signal is being received (the
changes from flashing to on).
· When the stride sensor is enabled for the SS-700/SS-500 (
stride sensor can perform measurement, if the exercise distance is short, there
is no change between sprinting and resting even if you reach the set time. Keep
exercising, and increase the exercise distance.
while measuring, you can change from sprint to rest, and then back
50
is flashing), there may not be a
P. 59), although the