Switching On The Appliance; Interrupting The Programme; Remaining Running Time Display; Terminating The Programme - Siemens Dishwasher Instructions For Use Manual

en

Switching on the appliance

Close the door.
Turn on the tap fully.
Rotate programme selector
required programme.
Switch on the main switch
The expected programme duration
is indicated on the numerical
display .
8
The programme sequence starts
automatically.

Remaining running time display

When the appliance has started, the
expected programme running time is
displayed. The programmed running time
is affected by the water temperature, the
number of dishes, as well as the degree
of soiling. If these conditions are changed,
the running time (depending on the
selected programme) can vary greatly.
As the effect is not detected until a
programme is running, the time may
be longer or shorter than expected.

End of programme

The programme has ended when a figure
appears in the numerical display

Switching the dishwasher OFF

Several minutes after the programme has
ended:
Set the main switch
Turn the water tap off.
(Does not apply when Aqua-Stop unit
has been fitted)
Remove dishes, etc. when they have
cooled down.
20
to the
3
.
1
.
8
to OFF.
1

Interrupting the programme

Set main switch
Indicator lights extinguish. The
programme is retained in the
dishwasher memory.
If the hot water was switched ON or the
appliance has already heated up and then
the appliance door opened, leave the door
ajar for several minutes and then close.
Otherwise, the appliance door may fly
open due to expansion.
In order to continue with the stored
programme, set the main switch to ON
again.

Terminating the programme

(Reset)
Only when the main switch is on:
Rotate programme selector to the
Reset position. The digital display
indicates after approx. 3 sec.
The programme sequence lasts
approx. 1 min.
When the programme has run,
switch off the main switch
To restart, rotate the programme selector
to the required programme. Switch on
3
the main switch
1
sequence starts automatically.

Changing the programme

It is possible to change the programme
within 2 minutes after you have switched
the dishwasher on.
Should it be necessary to change the
programme after this period, the
programme cycle that has already been
begun (e.g. washing) will be completed
first of all.
The new remaining time displayed is the
sum of the remaining time from the
preceding programme cycle and the
remaining time attributable to the new
programme that has been selected.
to OFF.
1
.
1
. The programme