Setting The Pan Offset - Honeywell ACUIX User Manual

Configuring PTZ Control

Setting the Pan Offset

26
To enable/disable finding home on startup:
1. If necessary, disable Startup State Restore (see
Restore on page 27).
2. Select 3 Control Options

on Startup ON (default) or OFF.
3. If ON is selected, the following message appears:
Extreme Caution: This will cause the scan to move immediately
on startup. Are you sure that you want to do this? Y/N
Select Y (yes) to continue, or select N (no) to cancel.
The pan offset feature is useful when a new scan assembly is installed and the
programming from the existing ACUIX is transferred to the new ACUIX using the
upload/download feature.
The alignment of the new ACUIX may not be exactly the same as the old ACUIX,
causing the programmed positions of the presets to be off. Preset 0 is used to
define the location of the pan setting. To set the pan offset, you must know the
original positioning of preset 0.
To set the pan offset:
1. Select 3 Control Options

1 Pan Offset ON.
2. Exit the OSD menus until you have manual control of the dome.
3. Enter preset 0 on your controller. If the dome does not go to the previously
known position for preset 0, the pan offset function cannot be used.
4. Using the controller, position the dome where preset 0 should be.
5. Select 3 Control Options
2 Set Pan Offset.
6. Test the setting. Using the controller, reposition the dome and then enter
preset 0. The dome should return to the programmed position.
Setting the Startup State

4 Set Pan and Tilt Options

4 Set Pan and Tilt Options

4 Set Pan and Tilt Options

5 Find Home
.
 
6 Pan Offset
 
6 Pan Offset