Using Your Iron; Filling The Water Reservoir - Frigidaire fafi16d7Mb Use & Care Manual

USING YOUR IRON

Filling the Water Reservoir

1 always ensure that the iron is unplugged from the wall outlet
prior to filling the water reservoir.
2 if filling a hot iron, exercise extreme caution.
3 set the steam selector to the off position, open the cover of
the Water fill hole and place the iron in a vertical position.
4 pour water into the Water fill hole, making sure that the
water level does not exceed the Maximum fill line.
Ironing
1 for both dry and steam ironing, set the steam selector to
the off position. if you will be steam ironing, follow the
"filling the Water Reservoir" steps.
2 insert the power cord plug into a 120-Volt ac outlet. the
power indicator will illuminate to indicate that the iron is
receiving power.
3 press the fabric selector buttons to illuminate the type of
fabric that will be ironed and then place the iron on the heel
rest to allow it to heat up.
4 once the iron is heated for the selected fabric, the Ready
indicator will illuminate with a green light. the iron is now
ready for use.
5 if steam ironing, set the steam selector to the desired level
of steam output.
Turning Off and Storing the Iron
1 press the (-) fabric selector button to select the off position.
2 set the steam selector to the off position.
3 unplug from the outlet by grasping the plug and pulling.
never yank the power cord to unplug the iron as this may
damage the plug and cable.
4 if the iron will not be used the following day, empty the
water reservoir. ensure the iron is unplugged and turn
upside down over a sink. open the cover of the Water fill
hole and empty the water into the sink, gently shaking out
any water drops.
5 allow the iron to cool completely. loosely circle the cord
around the heel rest and store the iron resting on the heel
6