Before Setting Oven Controls - Frigidaire 139900900 Use & Care Manual

Table of Contents

Advertisement

Oven Vent Location
The oven is vented as shown below. When the oven is on,
warm air is released through the vent. This venting is
necessary for proper air circulation in the oven and good
baking results. Do not block oven vent. Never close off the
openings with aluminium foil or any other material. Steam or
moisture may appear near the oven vent. This is normal.
delay
bake
start
time
clock
set
my
favorite
9
Figure 8:
Do not block oven vent location
Always use pot holders or oven mitts when using the
oven. When cooking, the oven interior and exterior, oven
racks, and cooktop will become very hot which can cause
burns.
Protective Liners — Do not use aluminum foil to line the
oven bottom. Only use aluminum foil as recommended in
this manual. Improper installation of these liners may
result in risk of electric shock or fire.
Removing, replacing, and arranging flat or offset
oven racks
To arrange - Always arrange the oven racks when the oven
is cool (prior to operating the oven).
To remove - Pull the oven rack straight forward until it
reaches the stop position. Lift up front of oven rack slightly
and slide out.
To replace - Place the oven rack on the rack guides on both
sides of oven walls. Tilt the front of oven rack upward
slightly and slide the oven rack back into place. Be sure
oven racks are level before using.
1
2
3
keep warm
drawer
hi
4
5
6
med
powerplus
keep
bake
broil
convect
preheat
warm
7
8
9
low
self
convect
add
start
cancel
pizza
nuggets
chicken
clean
convert
a min
0
on·off
11

BEFORE SETTING OVEN CONTROLS

Type of oven racks
flat
oven rack
offset
oven rack
Figure 9:
Oven rack types
Oven Rack Descriptions
The flat oven handle rack has a handle to facilitate the
sliding of the rack when large amount of foods weigh on
it.
The flat oven half rack has a removable insert that can
provide extra space for larger food items. The right half
rack portion may still be used for other food items like a
casserole dish. To remove the insert, squeeze on the
left front insert side of the rack and tilt out clockwise. To
reinstall, insert rear hooks at back of insert and lay
insert down. Make sure both insert front hooks snap into
rack.
The offset oven rack is used to maximize cooking
space. The offset rack can be used in the lower rack
position to roast large cuts of meat and poultry.
Air circulation in the oven
For best air circulation when baking, allow a space of 2
inches (5 cm) around the cookware for proper air circula-
tion. Be sure pans and cookware do not touch each other,
the oven door, sides, or back of the oven cavity.
Hot air must be able to circulate around cookware for even
heat to reach the food.
flat handle
oven rack
17

Advertisement

Table of Contents
loading

Table of Contents