Table of Contents
Advertisement
HCD-DP700
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIA-
GRAMS.
(In addition to this, the necessary note is printed in each block.)
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
specified.
•
: internal component.
f
• C : panel designation.
Note:
The components identi-
fied by mark 0 or dotted
line with mark 0 are criti-
cal for safety.
Replace only with part
number specified.
• A : B+ Line.
• B : B– Line.
• H : adjustment for repair.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
f
: AM
E
: PB (DECK A)
d
: PB (DECK B)
G
: REC (DECK B)
c : digital out
g : MD (VIDEO)
• Abbreviation
CND : Canadian model
MX
: Mexican model
E51
: Chiri and Peru model
22
SECTION 6
DIAGRAMS
1
/
W or less unless otherwise
4
Note:
Les composants identifiés par
une marque 0 sont critiques
pour la sécurité.
Ne les remplacer que par une
piéce portant le numéro
spécifié.
Note on Printed Wiring Boards:
• X : parts extracted from the component side.
•
: Pattern from the side which enables seeing.
• Indication of transistor.
C
Q
These are omitted.
B
Q
B
C E
These are omitted.
E
Advertisement
Table of Contents
