Sanyo LCD-27XA2 Instruction Manual page 17

Menu Operation
Semi-auto T uning
Semi-auto T uning
This is used to preset a channel in any pro-
gramme position.
1
1
Select "Prog. Preset" with
Preset menu.
Preset Preset
Auto Tuning
Prog. Preset
Swap
Fine Tuning
2
2
Press to enter the Semi-auto Tuning
mode.
Semi Semi
Frequency
Position
System
Sound
3
3
Select "Position" with
To select desired programme position:
Press the Digit (-/--) button and enter
the position number (000-254) using 0-9
buttons.
or
Press to select programme
position sequentially.
Semi Semi
Frequency
Position
System
Sound
Skip
Memory
4
4
Select "Frequency" with
Semi Semi
Frequency
Position
System
Sound
Skip
Memory
in the
>
>
- - -
< >
271.65 MHz
007
Auto
BG
.
273.25 MHz
010
Auto
BG
OFF
OK?
.
273.25 MHz
010
Auto
BG
OFF
OK?
5
5
You can either...
a) Press the Digit (-/--) button, and enter
the frequency (5 digits) using 0-9
buttons referring channel table.
b) Press and release
frequency) or
frequency) to search a TV station.
Once a station is found, tuning will stop
automatically. Repeat until desired
station is found.
• If the clear picture cannot be obtained,
change the colour system with
• If the sound is not clear or no sound is
produced, change the sound system
with or
.
6
6
Select "Memory" with
OK button to memorize.
Repeat steps 3-6 to store other channels in
other programme positions.
7
7
Press the MENU button to exit.
Fine T uning
Fine T uning
1
1
Select "Fine Tuning" with
Preset menu.
Preset Preset
Auto Tuning
Prog. Preset
Swap
Fine Tuning
2
2
Press and hold
channel.
3
3
Press the MENU button to exit.
The tuning will be stored when you exit
the menu.
Any changes made by fine tuning will
remain even when the TV set is turned off.
(toward the lower
(toward the higher
or
, and press the
in the
>
>
- - -
< >
or to fine tune a
.
17
17