Camera Installation; Checking Unpacked Camera; Mounting - JVC VN-T16U Instructions Manual

Camera Installation

Checking Unpacked Camera

Mounting

All the installation and operations here should conform to your
Note
local electricity safety rules.
When you receive the camera from the shipping agency, please check whether
there is any visible damage to its appearance. The protective materials used for
the package of the camera can protect most accidental clashes during trans-
portation. Then you can open the box to check the accessories.
Please check the items in accordance with the list.
1. Attach the camera to a pending mount.
Insert the screws on the camera stand into either of the screw holes on the
base. Then tighten them up.
2. Mount the camera onto the ceiling/wall and fasten it securely.
3. Connect the Safety Wire (Fall Prevention Wire, not supplied) to the cam-
era and the wall/ceiling.
To prevent the camera from falling off, ensure that it is connected to a
firm place (ceiling slab or channel) using a Safety Wire (Fall Preven-
tion Wire is not supplied).
Pay also careful attention to the length, strength, wiring, and material
(insulating properties) of a Safety Wire (fall prevention wire) to be
Warning
used. The length should be as short as possible within the permissi-
ble range of the mounting length. The wire should be strong enough
to withstand the total weight of this product and the fixer. (Pay also
attention to the finishing at the end of the wire.) The thickness of the
wire's end of camera side should be less than 1 mm.
Must be isolated camera and the wall/ceiling which are connected by
Caution
a Safety Wire (Fall Prevention Wire).
10