Advertisement
[4] UNPACKING AND INSTALLATION
1. AR-D15
<Before installation>
•Start installation after checking that the DATA and COMMUNICATION
indicators on the operation panel are neither lit nor blinking.
•For installation, a power supply unit (AR-DC1) is needed.
<Parts included>
Front mounting
plates: 2 pcs.
Left adjuster: 1 pc.
Adjuster covers: 4 pcs.
1) Turn off the main switch of the main unit of the printer.
Turn the main switch located on the front side of the printer to the
"OFF" position.
Then remove the power plug from the outlet.
2) Attach the adjusters and adjust them.
<1>Insert the left adjusters to the stand/paper drawer.
<2>Turn the five adjusters to lower them until they touch the floor.
<3>Attach the each adjuster covers.
3
3
2
1
*
Be sure to attach the left adjuster to prevent overturning.
Caution: The lower tray cannot be pulled out unless the adjuster is
lowered to the specified position.
Rear mounting
Screws (M4x8):
plates: 2 pcs.
4 pcs.
Screw A (M4x8 / with SW):
1 pc.
"OFF"
3
2
2
3
2
AR-D15/D20 UNPACKING AND INSTALLATION 4-1
3) Put the main unit of the printer on the stand/paper drawer.
<1>Pull out the paper tray of the main unit until it stops and then remove
it by lifting both ends of the tray.
<2>Hold the main unit of the printer at the positions shown in the
illustration and put the main unit on the stand/paper drawer so that
the front side and the left side of the main unit are aligned to those of
the stand/paper drawer.
Notch
[Note]
When placing the printer on
the AR-D15, be sure to
place the harness bundle in
the notch in the desk rear
cabinet in order not to pinch
the power harness.
Caution: For installation of the main unit, it must be held by two persons
and installed without haste.
Front side
4) Connect the main unit to the stand/paper drawer.
<1>Attach the rear mounting plates using a supplied screw for each.
Rear mounting plate
Desk frame
Caution: Insert the rear mounting plates under the desk frame.
Rear side
Rear mounting plate
Screw
Screw
Mounting plate
Advertisement
