Sharp AR-D24 Service Manual page 8

11) Install the cassette rear edge plate.
Install the cassette rear plate to the position of the paper size to be
used.
12) Set the paper.
When setting the paper, do not exceed the height of the indication label.
Note: To make the paper center shift adjustment and the lead edge
adjustment, insert the power plug of the copier into the
power outlet, turn on the power switch, and perform the fol-
lowing procedure.
13) Perform the center shift adjustment.
Set a document on the document glass and make a copy.
*If the image center is shifted, perform the following procedure.
1. Execute SIM 50-10 with the key operations on the copier.
2. Turn on the Auto lamp and the lamp of a corresponding tray by
Light and Dark key, Enter the set value with the keys on the opera-
tion panel to perform the center shift adjustment, make a copy
again, and check that the center is not shifted.
• When the set value is increased, the image is shifted to the rear
side.
• When the set value is decreased, the image is shifted to the front
side.
After completion of the adjustment, press the
mode.
14) Perform the lead edge adjustment.
Set a document on the document glass, and make a copy.
1. Execute SIM 50-1 with the key operations on the copier.
2. Turn on the Auto lamp and the lamp of a corresponding tray by
Light and Dark key, Enter the set value with the keys on the opera-
tion panel and make a copy to check that the lead edge is within the
specified range.
• When the set value is increased, the copy image moves forward.
• When the set value is decreased, the copy image moves back-
ward.
After completion of the adjustment, press the
mode.
AR-D25/D24 UNPACKING AND INSTALLATION
– 6 –
key to cancel the
CA
key to cancel the
CA