TABLE OF CONTENTS
1.
GENERAL ································································
2.
2-2. MAIN BOARD ································································ 14
2-5. CABINET ········································································· 16
2-8. DRUM ASSY ··································································· 17
3.
3-1. ADJUSTMENTS ······························································ 18
4.
4-4. PRINTED WIRING BOARD ·········································· 34
4-5. SCHEMATIC DIAGRAM -MAIN SECTION - ········· 39
4-6. SCHEMATIC DIAGRAM -AUDIO SECTION - ······ 42
5.
6.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
··································· 53
- 2 -
3