TABLE OF CONTENTS SERVICE SAFETY PRECAUTIONS ............................ 3 IMPORTANT INFORMATION ............................... 5 CLEANING ................................... 6 LOCATION OF CONTROLS ..............................7 LAYOUT OF MAJOR BOARDS ............................9 MECHANICAL DISASSEMBLY ............................10 EXPLODED VIEW ................................16 PACKING DISASSEMBLY ..............................17 TROUBLESHOOTING ............................... 18 CHASSIS AND CABINET REPLACEMENT PARTS LIST ....................
SERVICE SAFETY PRECAUTIONS • The caution items shown here describe major safety issues and should always be observed. • The meanings of the various indications are as follows. Indicates a hypothetical situation in which service personnel and nearby third parties, or even WARNING end users due to a product defect after the service operation is completed, could possibly be in danger of injury or even death in the event of operational error.
Page 4
WARNING • Always advise users to keep children away. There is danger of injury to children from tools, disassembled products, etc. KEEP CHILDREN AWAY • Always disconnect the power plug before starting work whenever power is not required. Failure to disconnect the power plug before starting work can result in electrical shock. UNPULUG •...
IMPORTANT INFORMATION About Permanent after-image • Due to the characteristics of a plasma screen, if the same image is displayed for an extended period of time, permanent after-image (image retention) in part of the screen may result. As a result of accu- mulative effect, brightness deterioration results.
CLEANING Remove the power plug before cleaning. Do not use solvents such as benzine or thinner to clean the TV. – These solvents may distort the cabinet or damage its finish. – If rubber or vinyl products remain in contact with the TV for a long time, a stain may result.
LOCATION OF CONTROLS TheaterLink Power indicator TV front (IR pass through) Remote sensor Push up Push up Left pocket panel Right pocket panel TV/VIDEO MENU VOLUME CHANNEL POWER VIDEO-3 IN HEADPHONE AUDIO S-VIDEO VIDEO L/MONO MENU POWER Headphones Channel TV/VIDEO VIDEO-3 jack Menu...
Page 8
Remote Control POWER turns the TV on and off. SLEEP allows access to the automatic TV shut-off function . LIGHT The first press of the LIGHT button lights the keypad and turns on the Illumination mode. With the Illumination mode on, pressing any other key lights the keypad for 5 seconds (10 seconds if you’re in programming mode).
LAYOUT OF MAJOR BOARDS E001 U006E SCALER BLOCK G-HYPER Module U003 U800 LOWB1 Board MAIN POWER Module U006C U004 OSD/MICON LOWB2 Board U005 A-OUT Board U006A U006B FRONT / AV Board KEY Board E003 DVI Board U801 SUB POWER Module U001A SIGNAL Board U001C...
MECHANICAL DISASSEMBLY ■ Removing the rear cover Note: Be sure to lay down the main body (by placing its screen downward) for disassembling. • Remove 25 screws (A). • Remove 16 screws (B). • Remove 6 screws (C). – 10 –...
A210 A213 PIECE, CONTROL BOX, AV REAR PIECE, CONTROL BOX, KEYREAR A211 A207 A208 A212 PIECE, CONTROL BOX , KEY FRONT ASSY, 42HP83 A407 WIRE HOLDER, NYLON66 D6.8 PIECE, CONTROL BOX, AV FRONT ASSY 42HP83 A201 BEZEL, 42HP83 A532 A205 DECORATIVE, GLASS SIDE –...
TROUBLESHOOTING NO SOUND (All source) Disconnection of SPK, (A-OUT) or the defect of SPK P601 #2 (Lch )or #4(Rch) OK? Change the SPK. (A-OUT) (A-OUT) Check the MUTE_AUDIO P610A #1 (Lch) or #2 (Rch) Q610 #5 (MUTE) is Low (0V)? line.
Page 19
NO POWER ON Relay sounds? Check 5V-1. Check the #9 of P807 by disconnecting M807. Replace PFT-422. Check the Microcontroller, POWER_TV is HIGH Light Receiving Unit and after connecting the M807 peripherals. again? Check Q819, D819 and peripherals of LOWB1. Replace PFT-422.
• The part number must be used when ordering parts, in order to assist in processing, be sure to include the Model number and Description. • The PC board assembly with mark is no longer available after the end of the production. Model : 42HP83 Capacitors ..... CD Ceramic Disk : Plastic Film : Electrolytic Resistors ....
Page 21
Location Location Parts No. Description Parts No. Description C876 24617030 ELECTROLYTIC, 16V 2200UF M CE50 24617043 ELECTROLYTIC04CH 35V 1000UF M C880 24669100 ELECTROLYTIC, 50V 10UF M 3A CE51 24539104 PLASTIC FILM, 50V 0.1UF J C881 24666470 ELECTORLYTIC, 16V 47UF M 3A CE52 24214221 CERAMIC DISC, 500V B 220PF K...
Page 22
Location Location Parts No. Description Parts No. Description CV38 24109102 CERAMIC CHIP, 50V B 1000PF K CY516 24109103 CERAMIC CHIP, 50V B 0.01UF K CV39 24109102 CERAMIC CHIP, 50V B 1000PF K CY517 24092731 CERAMIC CHIP, 16V B 1UF K CV40 24794101 ELECTROLYTIC, 16V 100UF M...
SPECIFICATIONS Plasma Colour TV Television System NTSC standard Channel Coverage VHF : 2 through 13 UHF : 14 through 69 Cable TV : Mid band (A-8 through A-1, A through I) Super band (J through W) Hyper band (AA through ZZ, AAA, BBB) Ultra band (65 through 94, 100 through 125) Power Source 110-240 V AC, 50/60 Hz (See page 7.)