JVC AV-48P777/H Service Manual page 14

3.1.19 REMOVING THE PROJECTION UNIT (Fig.2)
• Remove the SPEAKER GRILL.
• Remove the FRONT PANEL.
• Remove the FRONT CONTROL BOX.
• Remove the REAR PANEL.
• Remove the MAIN UNIT.
(1) Remove the CRT SOCKET PWB.
(2) Remove 4 screws [a].
(3) Pull out the PROJECTION UNIT upward.
NOTE :
• Refer to "PROJECTION UNIT REPLACEMENT" when tak-
ing out and replacing the PROJECTION UNIT.
• When wire clamps are removed during work, use care to re-
store them precisely to their original positions. Performance
can be affected if these are not returned to the original posi-
tions.
3.1.20 REMOVING THE HV DIVIDER (Fig.2)
• Remove the REAR PANEL.
(1) Remove 1 screw [b].
(2) Remove the HV DIVIDER.
NOTE :
• Wires of the transformer (FBT) and CRT of each PROJEC-
TION UNIT can be removed by turning the connector portions.
• If necessary, remove the anode wires, and replacing the HV
DIVIDER, take care to correctly engage the connector.
3.1.21 REMOVING THE REMOTE SENSOR PWB (Fig.2)
• Remove the REAR PANEL.
(1) Remove 1 screw [c].
(2) Remove the REMOTE SENSOR PWB.
3.1.22 REMOVING THE COOLANT PAN (Fig.2)
• Remove the REAR PANEL.
(1) Remove 2 screws [d].
(2) Remove the COOLANT PAN.
1-14 (No.YA455)