Table of Contents
Advertisement
Model 562A
Section III
01081-1
e. Shift the two ribbon spool retaining springs away from the spools, and
remove spools.
f.
Take the ribbon out of the mechanism.
Save the empty spool.
g. Hook end of new ribbon on empty spool.
Wind about 10 inches of
ribbon on the spool so that the rever sing rivet is on the spool.
h. Install new ribbon by feeding it over the ribbon rollers and between the
print wheels and paper tape.
i. Feed ribbon through the slots in the reversing arms and around the
lower guides.
Ribbon must be twisted 90
0
between the ribbon roller and the
slot in the rever sing arm.
j.
Place ribbon spools on their shafts.
Fasten spools in place with the
spool retaining springs.
Ribbon must feed out from the bottom of each spool.
k. Replace printer mechanism in cabinet and tighten retaining screws.
3-4. TAPE DUPLICATES.
Transparent paper,
~stock
no. 9251-0052 is recommended for use in the
recorder.
This paper produces much less paper dust and copies can be
easily made with duplication machines.
If duplicate tape records are
required from standard paper, contact print duplicating methods, such
as the ozalid process, can be used by printing directly from the original
tape records.
3-5. PROGRAMMING THE RECORDER.
The recorder can be programmed to accept different codes if the proper
column boards are installed.
The column boards may be inter-mixed if desired.
The standard recorder is supplied with six +1224 BCD column boards, with
connectors installed to accept a total of nine column boards.
If more than
nine column operation is desired, J201 must be installed with the connectors
that attach to the rear of the column boards (PIIO-PIl5).
Normally JIOl supplies data to column boards Al-A9, but connectors PIOl-
PI09 can be connected to supply data to any of the column boards the operator
desires.
J201 can supply data to any of the remaining column boards.
Con-
nectors PIIO-Pll5 can be connected to supply data to six column boards.
3-6. PROGRAMMING THE CONTROL BOARD (AI3).
Connectors P20l and P202 supply control signals to the data sources, and
return data source signals to the control board.
Connector P20l is con-
3-3
Advertisement
Table of Contents
