Operating The Triple Surface Radiant Elements - Electrolux Electric Cooktop Use & Care Manual

OPERATING THE TRIPLE SURFACE RADIANT ELEMENT
Both the 30" and 36" cooktops are equipped with "Triple" surface radiant elements
located as shown in Figs. 1 & 2. A touch key pad on the element controls is used
to select one of the 3 positions of the element. Symbols and indicator lights on
the control panel are used to indicate which coil of the triple radiant element will
heat. The symbol indicates that only the inner element (See Fig. 3) will heat.
The symbol indicates that both inner and middle elements (See Fig. 4) will heat
together. The
will heat. You may switch from either of these settings at any time during cooking.
To Operate the Triple Surface Element:
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the
light above the
within 20 seconds the request to Power ON the cooktop will clear.
3. Touch and hold the
a beep is heard. The display will show " -- ".
Note: If no further pads are touched within 10 seconds the request to
power the element ON will clear.
4. Select the INNER (Fig. 3), MIDDLE (Fig. 4) or ALL 3element (Fig. 5) to heat by touching the
key pad.
5. Touch pad once to turn ON the power level to
of the or pad will decrease or increase the power level from
levels between 3.0 and 1.0 will decrease or
ower level available.
y time while the element is ON.
etting and then turn to a lower setting to
s a constant amount of heat at each
xtending beyond the bottom edge of the
ll for the surface heating area.
e
if no other surface element is used touch the
Note: The HE message will appear in the display after turning the control knob to OFF if the
cooktop is still hot and remain on until the heating surface area has cooled sufficiently.
NO NO TE TE
NO NOTE NO TE TE
See the Recommended Setting for Surface Elements chart, on page 12, to make the correct setting.
Fig. 4
O O P O O
Setting Surface Controls
symbol indicates that all 3 portions of the element (See Fig. 5)
key pad until a beep sound. The power indicator
POWER
will turn ON. Note: If no other key pad is touched
POWER
pad for the desirede triple element position until
On/Off
HI. Touch pad once for
9.0
Lo.
pad once to turn the element OFF and
On/Off
key pad to turn off the cooktop.
POWER
15
Fig. 1
Fig. 2
Fig. 3