Unpacking; Proper Location - Haier Aqua Fontana WDBF01 User Manual

uNPACKING

1. R emove all packing materials. This includes the foam and all adhesive tape
holding the accessories inside and outside.
2. I nspect and remove any remaining packaging, tape and printed material
before turning on the water dispenser.
Note: A llow the water dispenser to stand in an upright position for at least
10 hours before turning on the power.

PROPER LOCATION

• T o ensure that your water dispenser works at the maximum efficiency it was
designed for, you should install it in a location where there is proper air
circulation and electrical connections.
• M aintain a sufficient distance (about 6-7 inches, 15cm) between the wall and
the back of the unit. Avoid locating the water dispenser in direct contact with
sunlight, water and heating units. Room temperature should not exceed 90˚f
(32˚C) or drop below 32˚f (0˚C) for optimal functioning.
• S elect a suitable location for the unit on a hard even surface away from direct
sunlight and heat sources (e.g., radiators, baseboard heaters, cooking
appliances, etc.).
Note: H ot and cold water will not be instantly available as the unit will need
time to heat up and cool down the water.
CAUTION: DO NOT turn on "Hot Water Switch" and the
"Cold Water Switch" (not on all models) in the rear
of the water dispenser until water flows through
both Hot and Cold water faucets.
English
4